Conext Automatic Generator Start

Conext Automatic Generator Start is Xanbus ™-devices that can automatically activate a generator to provide XW ™ Hybrid Inverter / Charger charging discharged battery, or provide additional generation capacity for peak loads.

Product information < br />
XW AGS intelligently controls the alternator, thereby eliminating the time spent on monitoring the battery and inverter loads. It does this by continuously monitoring battery voltage, charge status, or inverter-charge mode, the generator starts and stops when the battery needs additional charging. XW AGS also drives the generator to assist system XW ™ Inverter / charger when power consumption is high.
XW AGS can be set in accordance with the objectives for each polzoatelya. The user can determine whether the generator is to be activated at a low voltage battery charge status, thermostat or the load on the inverter (s). Setting Quiet Time prevents starting the generator at an inconvenient time, such as overnight. LEDs indicate the status of the XW AGS, and all user settings are programmed through the control XW ™ system- system tray (XW System Control Panel)

The performance capabilities:.

* Sovmestimost- XW AGS is connected with other Xanbus ™ HW system devices without requiring additional components, control cards or other specific control panel devices
* runs generators with AC or DC generator with a two-wire or three-wire control circuit
* comprehensive tuning Configurability Rella based on low battery voltage, change in the charging system, the high load of the inverter (s), the thermostat signals, scheduled start time, max. operating time, and quiet time setting
* Non-Volatile memory retains settings XW AGS, even in the event of a failure in the power supply network, or if the network connection is broken.

Note: XW AGS requires HW management system (XW System Control Panel) panel for configuring and monitoring

Features:.

* LED Display for otobrazhenieya a brief review of the status
* 20 connector pins from the generator and three built-in support for the relay 13 preset generator configurations
* Integrated emergency stop
* support Xanbus ™

Interacts with: XW Hybrid Inverter / Chargers (XW 4024, 4548, 6048), XW Solar Charge Controllers (XW-MPPT 60-150), and the XW System Control Panel

Electrical characteristics:
Nominal input voltage 15 Vdc4000 W
maximum load current 200 W mA8000
Communication physical layer Two, CAN
relay contact voltage rating of 12 V DC, 30 V DC maxTrue sinusoid
overcurrent relay contact 5 current Adc95%
communication protocol Xanbus ™
maximum length of the cable 130 '(40 m)
Mechanical data Mounting
Wall, 4 X # 6 screws included
Dimensions (H x W x D) 3.75 x 5.75 x 1.5 "(95.5 x 146 x 37 mm) 0.5 Weight
pound (0.225 kg)
Transport dimensions 10.5 x 8.5 x 2.5 "(267 x 216 x 64 mm)
weight of 1.70 pounds (0.77 kg)
Connectors two Xanbus ™ RJ45-8 connectors, one 20-pin connector Pluggable (Tyco Mate 'n' Lok two connectors)