Battery Management System VE.Bus BMS

VE.Bus BMS protects each single cell lithium battery zhelezofosfatnoy Victron (LiFePO 4 or LFP).
Each individual battery cell LiFePO 4 is to be protected from overvoltage and overheating voltage.
Batteries Victron LiFePO4 integrated into a balanced control system, temperature and voltage (acronym: BTV) and connected to the VE.Bus BMS with two sets of round M8 connector cords.
BTV several batteries can be connected in series.
Up to ten batteries in parallel and can be up to four
batteries can be connected in series (BTV simply connected to the network), so that the battery 48 can be assembled to 3000Ah.
BMS will:
disable or disconnect a load in the case of implicit cell under tension;
reduce the charge current in the event of an imminent surge, or cell overheating (only products VE.Bus);
off or disable the battery charger in the event of imminent surge cells or overheating
Protects system 12V, 24V and 48V
BMS Operating voltage:.. 9 to 70 VDC
communicates with all products VE.Bus
VE.Bus BMS connected to the converter MultiPlus, Quattro or Phoenix with standard cable RJ45 UTP.

load switching output load is disconnected, as a rule, high and becomes free floating when approaching the cell under < br /> voltage. . The maximum current: 2A
output for load disconnection may be used to control
- remote on / off the load and / or
- remote on / off electronic switch load (battery protection)
disabling charge
output charging current is usually high and becomes free floating in the case of imminent
cell voltage or overheating. Supply Current: 10mA
Exit to turn off the charging can be used to control
- Remote on / off the charger and / or
- relay Cyrix-Li-Charge and / or
- battery Cyrix-Li-ct

LEDs
- enabled (blue): VE.Bus products included
- cell> 4 or temperature (red).: low battery level is disabled due to imminent
cell voltage or overheating
- cell> 2.8 B (blue). high levels of load off
input voltage range 9 - 70 VDC.
current load, 10 mA normal operation (except for switching off the load current)
current load, low voltage 2mA cell
output for disconnecting the load

Normally high limit current source : 2A
leakage current: 0 A (free floating output)
Yield off

Normally high limit current source 10 mA
leakage current: 0 A (output free pla vanie)
GENERAL
communication port VE.Bus two RJ45 connector for connecting to all products VE.Bus
Working temperature -20 to + 50 ° C 0 - 120 ° F
humidity Max. 95% (non-condensing)
degree of protection IP20
BODY
material and color ABS, matte black
Weight 0.1 kg
Dimensions (hxwxd) 105 x 78 x 32 mm